Hi guys in a Chiller pickle.
I have a an Rtac Trane chiller unit, second circuit had what seemed to me a bad Evaporator liquid level sensor. It was always at 1.1 in or above starving the evaporator bc of this. Needles to say recovered 139 lbs out of 210 lbs of r134a. Removed old liquid sensor and even outside of canister was still reading 1.1in. Replaced with new sensor installed and binded and got desired .1 reading after install. Began the process to leak serach and recharge. Somewhere in this process my sensor went to simple no reading dashes ------. Resetting was no help, Circuit will not run on these conditions and help? Im very confused.
![]()
![]()
![]()
I have a an Rtac Trane chiller unit, second circuit had what seemed to me a bad Evaporator liquid level sensor. It was always at 1.1 in or above starving the evaporator bc of this. Needles to say recovered 139 lbs out of 210 lbs of r134a. Removed old liquid sensor and even outside of canister was still reading 1.1in. Replaced with new sensor installed and binded and got desired .1 reading after install. Began the process to leak serach and recharge. Somewhere in this process my sensor went to simple no reading dashes ------. Resetting was no help, Circuit will not run on these conditions and help? Im very confused.
